| View previous topic :: View next topic |
| Author |
Message |
pkrboo
Force Sensitive
Joined: 22 May 2015
Posts: 11
Location: United Kingdom
|
 Posted: Thu Apr 06, 2017 5:20 pm Post subject: Wiring Loom conversion |
 |
|
I have an engine and loom out of a 1998 Forester. It is the one with the ECU attached to the engine itself. The way i see it it should be easier to sort.
However, it seems impossible to find any wiring diagrams for it.
Does anyone have a wiring diagram for an X6 ECU that bots to the engine? |
|
| Back to top |
|
 |
Kai
Jedi Guardian
Joined: 14 Nov 2008
Posts: 1226
Location: Village life.... Enter the Vale
|
| Posted: Sat Apr 15, 2017 10:13 pm Post subject: |
|
|
In my limited experience.....
You are far better off searching for the subaru service manual for the donor vehicle rather then a wiring diagram for a specific ECU code.
I've found the Impreza turbos subaru service manuals on PDF for both classic and facelift models which neither ever specified the ECU code. Even then I found the best source for rewiring the ECU was in EFI trouble shooting area of the manuals and not the electrical wiring diagrams.
_________________
Think......
Don't sleep and drive!!! |
|
| Back to top |
|
|
Kai
Jedi Guardian
Joined: 14 Nov 2008
Posts: 1226
Location: Village life.... Enter the Vale
|
|
| Back to top |
|
|
pkrboo
Force Sensitive
Joined: 22 May 2015
Posts: 11
Location: United Kingdom
|
| Posted: Wed Apr 19, 2017 6:57 am Post subject: |
|
|
Cheers Kai, those links are for the multiplug ECU this one has a single B84 38 pin conenctor or so.
i'll keep searching too and keep guessing while i cut wires!!! |
|
| Back to top |
|
|
Kai
Jedi Guardian
Joined: 14 Nov 2008
Posts: 1226
Location: Village life.... Enter the Vale
|
| Posted: Sun Apr 23, 2017 8:03 am Post subject: |
|
|
I'm open to being corrected as I'm by no means an expert, but to my knowledge all subaru have the ECU placed in the left hand side footwell and are not attached to the engine. Also the phase 2 ECU's are all three plug units.
_________________
Think......
Don't sleep and drive!!! |
|
| Back to top |
|
|
pkrboo
Force Sensitive
Joined: 22 May 2015
Posts: 11
Location: United Kingdom
|
| Posted: Mon Apr 24, 2017 7:07 am Post subject: |
|
|
| no, there were some with the ECU on the Engine, 2 plugs on it, one plug to the car and one plug to the engine sensors. ill see if i can do a pic |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
