Throttle body reverser in a split?

ping

Do i need to reverse it or will it fit?

splitbus67 · Padawan Joined: 22 Mar 2011 Posts: 52 Location: Upt Norf

Ping

What did you do regarding the throttle body did you get the induction pipe on without using a reverser?

ping · Posted: Fri Jul 15, 2011 2:16 pm Post subject:

It just fits without being reversed, it does touch the fuel tank but i'm ok with that. Have a look at my pics in completed conversions.

splitbus67 · Padawan Joined: 22 Mar 2011 Posts: 52 Location: Upt Norf

Hi Ping

I've had a look at the photos and I have a couple of question, what part did you use to connect to the throttle body and what did you do to connect the mass air meter to the air filter?

Thanks
Phil

ping · Posted: Tue Jul 19, 2011 11:34 am Post subject:

I used the legacy manifold as it was in the legacy and at the MAF end i bought a 3" adaptor off ebay (Item number: 350374963454) and a 45 degree silicone bend, 64mm to 76mm off ebay (Item number: 350365897935) to connect the piper cross filter to the adaptor.
Hope this helps, Paul.

splitbus67 · Padawan Joined: 22 Mar 2011 Posts: 52 Location: Upt Norf

Nice one, that MAF adaptor has just saved me a load of time having to fabricate one

I will post a picture when I'm done.

Thanks Phil

splitbus67 · Padawan Joined: 22 Mar 2011 Posts: 52 Location: Upt Norf

Nice one, that MAF adaptor has just saved me a load of time having to fabricate one

I will post a picture when I'm done.

Thanks Phil

splitbus67 · Padawan Joined: 22 Mar 2011 Posts: 52 Location: Upt Norf

Just to complete this post and assist anybody else, this what I did.

Parts used

76mm - 70mm 90 degree Silicon bend - eBay 200487358396
MAF intake adaptor - eBay 350374963454
80mm Silicon straight pipe - eBay 270778626191
Subaru induction kit, cut down - eBay 230581618453